Creating a project for the controller 07 KT 97
1.1 Example project for the controller 07 KT 97
In the following procedure we want to create a small example project for the controller 07 KT 97, download
it and finally test it.
Task: Input E62_00 shall be routed to output A62_00 of the controller 07 KT 97.
Perform the following steps:
- Connect the controller 07 KT 97 to 24 V DC (refer to volume 2 – Hardware 07 KT 97).
- Connect COM1 of the controller 07 KT 97 to the serial interface of your PC.
- Start the 907 AC 1131 software. The project you edited last is opened. If necessary, close this project
by selecting “File/Close”.
- Select “File/New
(2661) Square D Pressure Switch 9012-GAW-2 (2661)
(S2-5) 9 TELEMECANIQUE XCS Z01 STRAIGHT-KEY TONGUES
(B1) 1 DIEFFENBACHER 233.1813.0147.10.D ANALOG TRAN
(B4) 1 NIB BECKMAN 511091 ELECTRODE B4
(B5) 1 NIB APOLLO 62-104-01 3/4″ BALL-CONE CHECK VALVE
(6608) Russell & Stoll Plug and Receptacle 3753 30A @25
(R2-1) 1 TERAOKA TPB-1770 MAIN BOARD. R2-1.
(M6-1) 1 SIEMENS SN-322 ENCLOSURE TYPE 1 M6-1
(8116) Allen Bradley 873E-EDZZ0750F4 Rightsound Ultraso
(8245) Dynamatic PC Board 15-240-146 (8245)
(B4) 1 MAGNETEK JEFFERSON ELECTRIC 240-211 POWERFOR
(B5) 1 EAGLE SIGNAL CG60A6 TIME DELAY RELAY B5
(B5) 1 NIB ASCO 90-683 SPARE PARTS REPAIR KIT B5